Step5: Examine the Peg. Now, examine the peg and make a note of where the hole for the string is. Sometimes there is more than one hole drilled. You can use the hole that allows you to wind the string the most efficiently. Make sure the peg is seated in the peg box hole loosely. Don't jam it in. Insert the end of the string into the hole in Tuneyour violin with our free violin tuning directions and sound files. The four strings on the violin are tuned in perfect fifths to the following notes: G, D, A, E. An A tuning fork, digital tuner, pitch pipe or a piano may be used to assist with tuning. The violin is tuned to the following notated pitches (click on the notes to hear the pitch) Removethe electric components from inside the guitar. Once your guitar is just a piece of wood, layer the copper foil tape in all the cavities in the guitar. Cut and trim tape to fit neatly in the recesses. Reassemble the guitar's innards. Apply copper foil tape to the underside of the pickguard to create shielding. Confirmthe strings are lined up evenly and then, with the screw in place, press down on the tree so the screw makes a small indentation in the headstock. This indentation should lie exactly between the two strings. Use it as a guide for drilling the mounting screw hole. Start with a pilot hole, using a very small bit. Thereare a few reasons why your strings might be touching the fretboard. The first reason is that your guitar's action might be too low. This means that the distance between the strings and the fretboard is too small, and the strings are more likely to come into contact with the frets. The second reason is that your guitar's nut might be Thisshould give you a perfect straight line between those two points but your neck is SUPPOSED to have a little curvature -- there should be a tiny gap between the top of the 7th fret and the bottom of the string. The gap should be about the same as the diameter of the 1st string, 0.011 inch (0.3 mm). .

how to fix e string on guitar